| Power supply |
24..230V AC/DC ±15% 50/60 Hz – galvanic isolation 2,5KV |
| Consumption |
6 Watt/VA |
| Operating conditions |
Temperature 0..45 °C, humidity 35..95 RH% (non-condensing), max 2000m a.s.l. |
| Front panel |
48 x 48mm |
| Material |
Box: PC UL94V2 self-extinguishing, front panel: PC UL94V2 |
| Sealing |
Front panel: IP65, Box and terminal blocks: IP20 |
| According to |
CE, UL |
| Analog inputs |
1x 16bit, K,S,R,J,T,N,B (autom. comp. of cold joint -25..85°C, ±0,2% F.S. ±1 digit F.S.), PT100, PT500, PT1000, Ni100, PTC1K, NTC10K (B3435K), 0..10 V, 0/4..20mA, 0..60 mV, Potentiometers 1..150KΩ |
| Sampling time |
Programmable up to 2,1ms (frequency up to 470Hz) |
| Digital outputs |
2x SSR 12 / 24 V DC – 25 mA max (overlapped to inputs) |
| Auxiliary output |
12/24 VDC – 30mA max for sensor supply |
| Relais outputs |
2 x 2A – 250V AC resistive loads |
| Analogue outputs |
1 x 4..20mA (40000 points ± 0,2% F.S ) or 0..10VDC (40000 points ± 0,2% F.S.) |
| Control algorithms |
ON – OFF with hysteresis, P., P.I., P.I.D., P.D. time proportional |
| Tuning |
Manual or automatic |
| Alarm mode |
Absolute / Threshold, Band, High / Low deviation. Alarm with optional Manual reset. Loop Break Alarm |
| Double P.I.D. |
Heating / Cooling with dual P.I.D. |
| Soft-Start |
Rising gradient programmable as Degree / Hour or fixed output % |
| Open/Close logics |
Open / Close logic for motorized valves |
| Software parameter configuration |
Memory Card, software LABSOFTVIEW, EASY-UP codes – Programming via APP (NFC) “MyPixsys” for Android and iOS devices |
| Digital inputs |
2x PNP (overlapped to SSR outputs) |
| Serial communication |
RS485 (1200..115200 Baud) galvanically isolated |
| Communication protocols |
Modbus RTU |
| USB |
1 x microUSB (for programming via MyPixsysLab software) |
| Programmer function |
Cycle with up to 12 steps and end-of-step recovery/waiting functions |
